This article covers various important aspects on how are solar panels installed.
Bury Conduit and Building the Platform
Bury passage from the house or building that may receive the ability to the world wherever the solar device arrays are placed. With the conduit in position, build a platform which consists of concrete made pillars of 4x4s that will support the solar array.
Mount the Panels
Once the platform is finished, use eight 24-volt 110-watt PV panels that are pre-fastened to form the array. For the upstairs loft, four 12-volt, 255-amp sealed batteries can store power collected by the panels. and at last, a 5500-watt power electrical converter and 40-amp charge controller are put in within the garage close to the quality electrical box. This expandable system ought to turn out thirty five,000 watt hours per month — enough to power a deep water pump, interior lights and a couple of appliances.
Moving on, the team mounts the panels to the platform. Angle brackets square measure used at the mounting points, and therefore the front feet square measure mounted initial. The feet square measure square and focused before being secured into place.
Secure the Rear Legs
Use meteorologic information to see the right angle of the solar array, then elevate and secure the legs on rear end.
Solar Modules – Wiring
Wire the star modules along and be part of them at a fuse combiner box. The modules ought to be stripped and wired in pairs before being connected to the fuse-box mounted at the platform and connected well to conduit out cables.
Once performing arts any trade, keep in mind to require all safety precautions. attributable to the danger concerned is left to professionals.
Inside terminal box, the stripped wires should be connected properly. during this instance, the red wires square measure connected to the positive terminal, and therefore the black wires to the negative terminal. Once connected, the wires square measure tired of something through the lowest of the junction box and connected to the corresponding positive-negative terminal blocks.
The solar breaker will first should be connected to a circuit breaker disconnect. The energy will then flow from the disconnect to a charge controller and subsequently to a battery bank to be stored. When needed, energy flows from the batteries back to circuit-breaker disconnect and from the disconnect to a power-inverter, The converted power will then flow into electric panel, where it provides electrical power for home.
The back up generator (gas) and pump (well ) are also connected to the solar system. The solar installer recommends the installation of two 240V power converters to the right of the main breakers
Connecting Cables to Control Panels
Run the electrical cable from the solar-array through the underground conduit. Connect cables to nylon rope for easy threading, and subsequently pulling the same via conduit to inverter-panels. Connecting the cables at the fuse combiner box at the base of array.
Grounding of the System
Tap a grounding rod to the earth near array. Leaving the long rod extending above the ground approx 6 inch. Running the copper grounding wire from the rod to the fuse box and from the solar panels to the fuse-box.